Characteristics of PPS Mechanical strength is exceedingly high, with flexural strength in particular exhibiting a high value, Excellent elastic recovery is also possessed. Possesses high toughness, while high values are also exhibited for compression and shear Characteristics. Possesses superior creep characteristics even under high temperatures and loads. In addition, Possesses superior fatigue resistance to repetitive stresses. Elongation and impact strength are high, and brittleness, a major drawback of traditional PPS, has been improved significantly. Can withstand immersion in 260 °C solder bath for 10 s, making the resin more than able to cope with electronic component surface mount technologies. Lonic impurities are low, and application is possible in applications where strict electrical properties are demanded. Little change in volume resistivity is shown over time, and there is almost no change in dielectric constant due to frequency or temperature. These characteristics make it an excellent insulative material. Weld strength is high, and superior secondary processability (screws, insertion, etc.) is exhibited.

Applications in PPS Connectors, sockets,IC card connector,Chip carrier,Gear of Copying machine,Tape recorder heat-mount,Stepping motor shaft ,Electric shaver base ,Stream hairdryer parts,Solenoid,DAT cylinder base,Water Pump impeller.

測試項目 Test items 測試標準 Test Standard 單位 Units GF30-V0 GF40-V0 填充物含量 Glass Fibre - % 30 40 比重 Specific Gravity ASTMD792 - 1.57 1.67 吸水率 Water Absorption ASTMD570 % 0.02 0.02 抗拉強度 Tensile Strength ASTMD638 Mpa 152 178 斷裂伸長率 Elongation ASTMD638 % 2.0 2.2 彎曲強度 Flexural Strength ASTMD790 Mpa 203 256 彎曲模量 Flexural Modulus ASTMD790 Mpa 10765 13843 缺口衝擊強度 IZOD Notched Impact strength ASTMD256 J/M² 73 77 洛式硬度 Rockwell Hardness ASTMD785 R R121 R124 熱變形溫度 Heat Deflection Temp ASTMD648 °C 260 260 阻燃性 Flammability Rating SGS UL-94 V-0 V-0 成型收縮率3mm厚 MD Moulding Shrinkage TD - % 0.30 1.20 0.40 0.70 以上數值係參考ASTM方法所測得，僅供選擇用途品級參考 All tests were run under laboratory conditions ASTM testing Procedures,The data are intended as general guide only.